Ferroalloy production process: Ovens. Early Ovens electrodes and other equipment to withstand less heat, therefore, requires less cooling water, ferroalloy silicon particles, a small amount must be controlled depending on the heat, ferroalloy silica fume, then the water must be unobstructed. Electrodes wind can not open, depending on the heat after, adjusting the amount of water and wind. In order to prevent oxidation of the bottom carbon brick, after all the preparatory work is completed, iron alloy, in the bottom layer of about 100mm coke powder (0 ~ 3mm), ferrosilicon alloy ultra-fine powder, then be oven. Ferroalloy smelting nature: the ferroalloy smelting, although varied, different equipment, methods range, but it fundamentally is the use of an appropriate reducing agent, the reduction of the redox process requires elements from the ore containing an oxide. Production should be by controlling the temperature, the slag composition and selection of a suitable reducing agent, etc., to promote beneficial elements needed to fully restore, and try to suppress the reduction of other impurity elements in order to achieve selective reduction purposes. _ _ Metallurgy ferroalloy ferroalloy silicomanganese New Year New Year by the Anyang Metallurgical Materials Limited. _ _ Metallurgy ferroalloy ferroalloy silicomanganese New Year New Year Anyang Metallurgical Materials Co., Ltd. (www.ayxyyj.com) (www.ayxcyj.com) this year introduced a new upgrade, the above picture is for reference only, please call this page or image Contact phone, for the latest information, contact: Mr. Wang.